How-to
How to Cut Onions With a Knife
How to cut onions with a knife: dice, slice, cut rings and wedges, with cut widths, safe finger placement and ways to reduce tears.
An onion falls apart the moment its root is gone, which is why the root end decides how easy every cut will be. Keep it attached while the knife works through the layers, and the onion stays in one piece whether the goal is a dice, thin slices or thick rings.
Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases.
A sharp chef's knife and a clean board are enough
One sharp chef's knife and a clean cutting board cover every cut below. Sharpness matters most, because a keen edge passes through skin and layers cleanly instead of crushing them, which gives tidier pieces and lets less of the sting escape into the air.
Blade shape changes how the work feels, from a classic chef's blade to a santoku or a flat-edged nakiri. For blade shapes suited to onion prep, see our recommendations on which knife to cut onions to buy.
Six steps to dice an onion
Dicing is the base technique, and slicing and chopping reuse the same setup. The root stays on until the last step because it holds the layers together.
- Cut off the stem end and leave the root end in place.
- Halve the onion from top to bottom through the root, so each half keeps part of it.
- Peel the papery skin from each half, taking off as few layers as possible.
- Lay a half flat side down with the root pointing away, then make even cuts along the lines of the onion, stopping short of the root.
- Turn the half 90 degrees and cut across the first cuts at the same spacing, holding the layers together with the other hand.
- Discard the root piece and repeat with the second half.
How wide to make the cuts
The spacing of the cuts sets the name of the result. Pieces of one size cook at the same pace, so match the width to what the recipe asks for.
| Cut | Width of each cut |
|---|
| Mince | About ⅛ inch |
| Small dice | About ¼ inch |
| Medium dice | About ½ inch |
| Large dice | About ¾ inch |
Slices, rings and wedges start from the same setup
Not every recipe wants a dice. Each of these starts with the stem trimmed and the onion peeled, and only the next cut changes.
- Half-moon slices: halve the onion, lay it flat side down and cut thin, long pieces across, keeping the root on for grip.
- Rings: slice a thin piece off one side so the onion sits steady, then cut across from the root end; thick rings suit frying, medium ones suit burgers and very thin ones suit salads.
- Wedges: halve the onion lengthwise, halve the halves again and cut further at an angle if the pieces are large; they suit roasting and grilling.
- Julienne: make lengthwise cuts about ⅛ inch wide, following the lines from root to tip.
Keeping fingers safe and tears down
Curl the fingertips of the holding hand inward so the knuckles guide the blade. This bear-claw hold is one of the first habits in developing knife skills, and it matters most on a round, slippery onion.
For tears, chilling the onion in the freezer for about 10 to 15 minutes before cutting helps, a sharp blade releases fewer of the irritating compounds, and leaving the root on while cutting helps a little. Cutting under running water is sometimes suggested, but a wet board and blade make slipping more likely.
Frequently asked
Does the direction of the cut change how an onion tastes?
Yes. Cutting widthwise, across the layers, gives a sharper taste, while cutting lengthwise, with the grain, gives a milder one, so pick the direction that suits the dish.
What is the difference between chopping and dicing?
Chopping makes chunks of similar but not exact size, typically around an inch across. Dicing demands uniform pieces no larger than about three-quarters of an inch, which matters because recipe timings assume a piece size and even pieces finish cooking together.