Explainer

What Is a Thermal Cooker?

A thermal cooker finishes cooking food in an insulated pot with no power. Learn how it works, how to use it and how it differs from a slow cooker.

A thermal cooker does most of its cooking after the heat is switched off. The food is boiled briefly on a stove, then sealed inside an insulated container that holds the heat for hours. That one habit explains both why people like these cookers and why they behave differently from anything plugged into a wall.

Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases.

A two-pot design that cooks on stored heat

A thermal cooker, sometimes called a vacuum flask cooker, pairs an inner cooking pot with an insulated outer container. The inner pot goes on a stove or other heat source to bring the food to a boil. It then moves into the outer container, which holds the heat so the food keeps cooking without a burner or any power.

The insulation varies by model. Some use a layer of insulating material in the outer walls, while others use a vacuum between double stainless steel walls. Either way the food is not cooked in a vacuum; the vacuum is only there to slow heat loss. Some models add a second, smaller inner pot so a main dish and rice can cook at the same time.

Five steps to cook in a thermal cooker

The method is the same for soups, grains, beans and braises, and only the boiling and resting times change. Defrost frozen ingredients first, since they pull the temperature down. Fill the pot more fully for long cooks such as dried beans than for something quick like rice.

  1. Cut the ingredients into even pieces and put them in the inner pot with the liquid.
  2. Set the pot on the stove and bring it to a full boil for the time the recipe gives.
  3. Move the hot pot into the outer container right away, before it cools.
  4. Close the lids tightly and leave the cooker alone, because opening it lets heat out.
  5. Open it once the recipe time has passed and check that the food is cooked through.

How it differs from slow cookers and pressure cookers

A slow cooker keeps its heating element running to hold a steady temperature, so it stays plugged in and can dry out food left too long. A thermal cooker uses no energy after the first boil, which makes it portable, but the food only cooks while it stays hot, so the cooking window is limited by how well the container holds heat.

Pressure cookers also save energy, but they do it by raising the boiling point so food cooks faster, and their sealed lid means the dish cannot be checked partway through. A thermal cooker cooks more gently and more slowly, which suits cuts of meat that do better with moist, lower heat.

What it does well and where it falls short

The strengths are clearest with long, forgiving recipes, and the limits come from relying on stored heat. Capacity and the number of inner pots differ between models, so for sizes and pot layouts, see recommendations on which thermal cooker to buy.

Why the first boil matters for safety

Because nothing reheats the food, the starting temperature decides how safe the result is. Bring the contents to a rolling boil before they go into the container; with large chunks of food, boil a little longer so the heat reaches the middle. Hot food should stay above 60°C (140°F) and cold food below 4°C (40°F), since bacteria multiply in between.

Dried kidney beans and some other beans contain a natural toxin that is only broken down by a hard boil of at least 10 minutes, so they should be boiled that long on the stove before the pot goes into the container. For any care or timing limits on a specific model, follow the maker's instructions.