How-to

How to Use a Pizza Peel

How to use a pizza peel: dust it, build the pizza fast, launch with one quick pull, and fix the sticking problems that ruin a pizza at the oven door.

A failed launch rarely has anything to do with the dough. The pizza sticks because it sat on the peel too long, because the dusting was the wrong kind, or because the push into the oven was slow and hesitant. A peel exists for one reason: the best crust bakes on a surface that is already blazing hot, and a long flat paddle is the only sensible way to reach it. The technique is a few small habits, and most of them happen before the pizza ever leaves the counter.

Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases.

Dust the peel with something coarse

Plain flour is fine-grained and soaks up moisture within seconds, so the layer under the dough stops helping almost immediately. A coarser dusting keeps working longer. A mix of half semolina and half of the flour used in the dough lets the pizza roll on small grains and adds a faint nutty note to the underside of the crust. If there is no semolina in the kitchen, flour alone will do.

Keep the layer thin. A peel buried in dusting only leaves loose flour that scorches when it lands on a hot stone, and it can taste bitter on the next bake.

Six steps to launch a pizza

The launch itself takes seconds; the preparation decides whether it works. Have the oven or stone fully heated before the dough touches the peel, then work through these steps without pausing.

  1. Stretch the dough on the counter to its final size, then dust the peel and lay the dough on it.
  2. Pull any edges that shrank back out to the full diameter.
  3. Add sauce, cheese and toppings quickly, sauce first, keeping everything wet away from the bare peel.
  4. Shake the peel gently; if the pizza slides freely, carry on, and if an edge grips, lift it with a scraper and add a pinch of dusting.
  5. Open the oven and hold the peel nearly level, only a slight tilt, with the front of the pizza reaching toward the back of the baking surface.
  6. Give one short, confident forward push, then pull the peel back sharply, like whipping a tablecloth from a table, and close the door.

Why pizza sticks and how to stop it

Almost every stuck pizza traces back to a short list of causes, and each one has a simple fix.

Wood launches, metal retrieves

Wood and metal peels do different jobs, which is why the usual advice is to own both. A wooden or composite peel has a porous surface that takes up a little moisture from the dough, so a raw pizza lets go of it more easily. A thin metal peel slips under a baked crust far better, which makes it the right tool for turning and retrieving. Whoever can afford only one is generally better off with wood for launching and a spatula for retrieval, while a metal peel suits a cook who works quickly.

See our recommendations on which pizza peel for ooni koda 12 to buy.

Getting the pizza in and out of a hot oven

In a home oven, the stone goes in first and heats for as long as is practical, at least half an hour and up to an hour. Pull the rack most of the way out so the peel can sit level over the stone instead of poking into a narrow gap. The stone loses very little heat if the whole move takes a few seconds, so speed matters more than worrying about the open door.

A pizza oven changes two things, distance and heat. The cooking floor sits farther from the opening, so a short-handled peel is the wrong tool, and a long handle keeps hands clear of the flame. Retrieval changes too, because a wooden peel cannot get under a baked pizza easily. Slide a thin metal peel flat under the pizza, turn it partway through the bake so the side facing the flame does not overcook, and lift it out in one smooth motion onto a board.

Practice and look after the peel

Rehearse before the real pizza is on the line. Lay a folded dish towel on the peel and work the push and pull toward the actual target, a stone or a board, at the same height as the oven so the motion feels the same. A stretched dough skin works for a few attempts too, but it dries out quickly. Technique also leans on the tool, since choosing the right peel size keeps the head close to the pizza and makes the shake and the pull easier to control.

Keep the peel dry between uses and never cut on it, because knife grooves catch dough on later launches. Wood should stay out of the oven and the dishwasher, as heat and water split it. Scrape off stuck debris, wipe it down and let it air dry. For oiling a wooden peel or any washing beyond that, follow the maker's instructions, since advice differs.

Frequently asked

Why do pizza peels have holes in them?

The perforations let excess flour or semolina fall away before the pizza goes into the oven, and the smaller contact area can reduce sticking. They are not a cure-all, though: if assembly is slow, the dough can sag into the holes and grip, so speed still matters.

Can you make pizza without a peel?

Yes, as long as there is a hot stone or steel to bake on. A rimless baking sheet, a cutting board or a serving platter can stand in for the peel, and some cooks build the pizza on parchment paper and slide it, paper and all, onto the hot surface.