Beginner
How to Use a Pasta Pot
How to use a pasta pot: set up the strainer lid or insert, size the water and salt, cook to al dente, then drain safely and save some pasta water.
A pasta pot is a stockpot with a built-in colander, and the whole point is the moment the pasta is done: there is no tipping a full pot of boiling water into the sink. That one change is also where most mistakes happen, because the draining method depends on which kind of pot is on the stove. Getting the water, the salt and the lift right takes a few minutes to learn.
Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases.
Two kinds of pasta pot, two ways to drain
A pasta pot is a tall stockpot paired with a strainer, so the pot and the colander are one piece of cookware. Some versions have a perforated inner basket that sits inside the outer pot and lifts out; others keep the pasta in the pot and use a lid with holes that locks on, so the water pours off when the pot is tilted. Locking handles, such as the twist-and-lock handles on the Gotham Steel 5 Qt Stock Pot, and a lock-and-drain lid, as on the Tramontina 8-Quart Pasta Pot, are examples of the lid style. The All-Clad Simply Strain 8 Qt. Multipot belongs to the insert style, with straining holes in the base of its insert.
The pasta pot comparison covers both designs side by side, including the capacity and handle details of each model. Knowing which style you own matters, since the draining section below differs for each.
Set the water, pot size and salt first
Pasta needs room to move, or it clumps. The usual rule is about 4 quarts of water for every pound of pasta, and the pot should be filled roughly two-thirds full so the water has space to rise when the pasta goes in. A pot that is too small for the box is the most common cause of gummy, stuck-together noodles, and the cure is a bigger pot, not more stirring.
Salt matters as well; the water should taste noticeably seasoned, and a common guide is one to two tablespoons for every four quarts. Add it once the water is boiling rather than into cold water. Salt sitting undissolved on the bottom of a stainless steel pot can leave small pits in the surface, and this is a simple way to avoid them.
Seven steps from cold water to al dente
With the pot sized and the salt measured, the cooking itself is short. These steps work for either style; with an insert pot, set the basket in place before the water goes in.
- Set the insert in the pot if yours has one, then add water to about two-thirds full.
- Cover the pot and bring the water to a rolling boil over high heat; a lid speeds this up.
- Remove the lid carefully, then stir in the salt.
- Add the pasta and stir right away to keep the pieces apart; long noodles soften within a minute or so and can be pushed under the water without breaking them.
- Leave the lid off, set a timer for a minute or two less than the package time, and stir every few minutes. Lower the heat slightly if the water climbs toward the rim.
- Taste a piece when the timer sounds; it should be firm to the bite with a little resistance, not crunchy. Cook another minute if it is not there yet.
- Scoop out a cup of the cooking water, then turn off the heat and drain.
Drain slowly and keep some pasta water
Reserve the cup of cooking water before anything else, because it is gone once the pot is drained. The starch in it helps a sauce cling and turn glossy; add it a spoonful at a time until the sauce loosens to the right texture.
With an insert, switch off the burner, put on oven mitts, and lift the basket slowly, letting the water run back into the pot as it rises. Pulling it up fast brings a surge of boiling water with it. Rest the basket on the pot rim or move it to the sink to finish draining, and pour out the remaining water only after it has cooled. With a strainer lid, lock it on according to the maker's instructions, wear mitts, and tilt the pot over the sink in one steady motion, keeping your face and hands clear of the steam.
Why pasta sticks, breaks or boils over
Sticking nearly always traces back to too little water or too little stirring in the first minutes, which is when the starch on the surface is tackiest. Pieces that arrive broken at the end usually have the same cause, so stir gently, especially along the bottom of the pot, and keep the water well above the pasta.
If the pot foams up to the rim, drop the burner to medium-high rather than lifting the lid and hoping. Skip rinsing after draining unless the dish is a cold pasta salad, because rinsing removes the starch that helps sauce adhere. For hot dishes, toss the drained pasta into the sauce rather than spooning sauce on top, adding a little reserved water as needed.
Frequently asked
Should you add olive oil to the pasta water?
Generally no. Oil does little to prevent sticking, which is better handled with enough water and regular stirring early on, and it can coat the cooked pasta so the sauce slides off instead of clinging.
Can a pasta pot cook anything besides pasta?
Yes. Any food that needs draining works, including beans, lentils, hard-boiled eggs and vegetables, and the pot doubles as a regular stockpot for soups and stocks when the strainer is not in use.