Four kinds turn up in home kitchens, and each is handled a little differently. For long-handled models with built-in presets, start with the digital bbq fork picks.
Beginner
How to Use a Meat Thermometer
How to use a meat thermometer: pick the right type, place the probe, read it and pull the meat on time for grilled, roasted and pan-cooked cuts.
Color and touch misjudge doneness often enough that guessing costs cooks both safety and juiciness. A thermometer fixes that only when the probe sits in the right spot at the right moment, and most bad readings trace back to one of those two things.
Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases.
Which thermometer type fits the job
- Digital instant-read: the most popular choice for home cooks; fast reads taken near the end of cooking.
- Dial: slower and less precise, but able to stay in thick cuts while they cook.
- Probe: a cable links the probe to an outside display, which suits long roasts and smoking.
- Infrared: reads surface heat only, so it cannot tell the internal temperature of meat.
Seven steps to an accurate reading
The method is the same for steak, chicken or a roast; only the spot and the wait change.
- Start checking a few minutes before the recipe's cook time ends, not at the beginning.
- Find the thickest part of the cut.
- Push the probe in so the tip sits in the center, clear of bone, fat and gristle.
- For steaks, chops and burgers, enter from the side to reach the middle.
- Wait for the display to settle; digital instant-read models usually need about 5 to 10 seconds.
- On a large roast or a turkey, repeat in two or three more spots.
- Compare the number with the target, and pull the meat slightly early if it is close.
Why pulling a few degrees early works
Thick steaks and roasts keep cooking after they leave the heat, so the temperature climbs while the meat rests. Taking it off a few degrees below the target, and a bit more for a big roast, lands it on the number instead of past it.
Color is a poor stand-in for this. Chicken can stay pink when it is done, and beef can look brown before it is safe, so the reading decides, not the look. For poultry the usual safe minimum is 165°F.
Adjusting the method to the cooking style
Where the heat comes from changes how the probe goes in and how long it stays. Fork-style models keep the hand farther from a hot grate than a short probe does, which helps over open flame.
- Grilling: enter from the side of a steak or burger to reach the center, and avoid pushing through thin cuts.
- Roasting: a probe with an outside display suits turkey or a beef roast, checked at the deepest points.
- Pan frying: test the center right after lifting the meat from the heat, and mind the hot oil.
- Smoking: leave a probe in for the whole cook and watch the slow climb.
Keeping the readings honest
A thermometer that has drifted gives false confidence, and even digital models need a check now and then; the ice-water and boiling tests are laid out under meat thermometer calibration methods.
Wash the probe in hot, soapy water after every use. Otherwise germs from raw meat can travel to the next food it touches.
Frequently asked
Is it safe to leave the thermometer in the oven?
Only leave-in probe thermometers are made to stay in during cooking. Instant-read and dial models are not built for oven heat and may melt or break, so check the maker's instructions before leaving any thermometer in.
Can you use a meat thermometer after cooking?
Yes, it can confirm that the thickest part has reached a safe temperature, which helps with grilled meat and roasts. Checking shortly before the meat leaves the heat still gives better control over doneness.