Beginner
How to Install an Under Cabinet Radio
How to install an under cabinet radio: test it, mark holes with the template, drill, and mount by hand. No electrician needed for plug-in units.
The part of an under cabinet radio install that goes wrong is rarely the drilling. It is the order of operations: a unit that turns out to be dead, a template taped a little off center, or a cord that stops two inches short of the outlet all show up after the holes are made. Most kitchen models are plug-in units that mount with a paper template and a few bolts, so the job takes basic tools and a short stretch of time, as long as the checks come before the drill.
Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases.
Check the unit and the spot first
Before anything is marked, plug the radio in and make sure it powers on. Finding out about a dead unit after it is bolted under a cabinet means taking it all back down. Then choose the cabinet, and let the outlet decide: the power cord has to reach without pulling tight or hanging in view.
The underside of the cabinet matters too. Solid wood holds screws well, while thin laminate or hollow panels can crack or let screws pull loose. Many models ship with their own template and mounting hardware; see the best kitchen under cabinet am/fm radio for models that include a remote and mounting hardware in the box.
- Pencil and scissors, for marking the template and cutting out the hole positions
- Drill and a set of bits, starting small and finishing at the size the supplied bolts need
- Tape, to hold the template steady against the cabinet
- Handheld screwdriver, for the final tightening
- The template and mounting hardware that came with the radio
Seven steps to mount it
The sequence below fits most plug-in under cabinet radios. If the manual shows a different bolt pattern or spacer arrangement, follow the maker's version for the hardware part and keep the order.
- Test the radio by plugging it in and checking that the display lights up and the tuner picks up a station.
- Pick the cabinet and confirm the cord reaches the outlet without strain.
- Cut out the hole markings on the template, find the center line by folding it in half, and tape it to the underside of the cabinet, centered.
- Mark each hole through the template with a pencil, then drill small pilot holes with a small bit.
- Switch to the larger bit the bolts call for and drill each hole through again.
- Hold the radio up to the cabinet with one hand, thread the bolts with the other, and turn each one by hand until the unit sits snug.
- Power it on, pair a phone or connect a cable if the model supports it, and set the clock.
Mistakes that cause most of the trouble
A few slips account for most redo work on this job, and each one is easy to avoid with a moment of checking.
- Skipping the pre-test, which turns a dead unit into a full uninstall.
- Taping the template off center, which leaves the radio visibly crooked with no adjustment once the holes are drilled.
- Tightening with a power drill instead of a handheld screwdriver, which can strip the mounting points so the unit never sits tight.
- Ignoring the cord, which ends in an extension cord across the counter.
- Drilling the final hole size straight away instead of starting small, which risks splitting the wood.
Frequently asked
What size drill bit do I need for the mounting holes?
Match the final bit to the diameter of the bolts that came with the radio; one clear instruction on a page puts it at a quarter inch for its model, but check your own hardware. Begin with a smaller pilot bit so the wood does not split, then open the holes up to the bolt size.
Do I need an electrician to install an under cabinet radio?
Not for a plug-in model. These units run from a standard household outlet through their power adapter, so no hardwiring is involved; the only requirement is an outlet within reach of the cord. If a unit asks for anything beyond plugging in, follow the maker's instructions.