How-to

How to Hone a Knife

How to hone a knife with a rod: the angle to hold, six steps, how many swipes and how often, plus signs the edge needs sharpening instead.

A knife that has gone dull is often not worn out at all. Its edge has simply bent over a little from use, and a few strokes on a rod can stand it back up. That is honing, and it is the quickest way to make a blade bite again, though it only works if the angle is right and the edge still has something left to straighten.

Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases.

Honing straightens the edge; sharpening replaces it

Every cut nudges the thin edge slightly sideways. Honing pushes it back into line without removing meaningful metal, which is why a honed knife feels sharper without being sharpened. Sharpening grinds steel away to make a new edge, and it is a separate, less frequent job.

A honing rod or steel does the work. A fine-grit ceramic rod is a gentle, dependable choice for most kitchen knives. The ceramic part should be a couple of inches longer than the longest blade it will serve, which keeps the stroke comfortable.

Match the rod angle to the edge

The goal is to hold the knife against the rod at the angle the edge was ground to. Most Western-style kitchen knives sit near 20 degrees per side, and Japanese-style blades are usually finer. The table gives the usual starting points, but the maker's own instructions win when they state an angle. Edge angle can differ between a chef's knife and a santoku, and the chef's knife vs santoku comparison covers why.

Knife typeTypical honing angle
German-style kitchen knifeAbout 20 degrees
Japanese-style kitchen knifeAround 15 degrees
Pocket knifeBetween 15 and 20 degrees
Serrated bread knifeShallow, on a rod made for serrations

Six steps to hone a knife

Two angle checks help before the first stroke. Hold the knife at 90 degrees to the rod and split that in half, then half again, for roughly 22 degrees. Or fold a sheet of paper in half twice and hold it beside the rod as a guide. When unsure, begin with a smaller angle and widen it, because an angle that is too wide works against the edge. Traditional single-bevel Japanese knives should not go on a rod at all; use a waterstone for those, or follow the maker's instructions.

  1. Stand the rod upright with its tip on a cutting board or folded towel so it cannot slide.
  2. Set the heel of the blade at the top of the rod, tilted to the angle for that knife.
  3. Draw the blade down and toward the body, moving from heel to tip, with light pressure and a steady wrist.
  4. Repeat on the other side of the rod, keeping the same angle.
  5. Alternate sides for two or three swipes each, then slice a sheet of paper to test the edge.
  6. Wipe the blade clean to remove steel dust before cutting food.

How often and how many swipes

Light and steady beats forceful. Pressure should be little more than the weight of the knife, and two or three swipes per side are usually enough when the edge was in decent shape.

For timing, honing before a cooking session works slightly better than after, since an edge can drift back over time. A cook preparing meals three or four times a week should hone at least once a week. A rod kept in a drawer or on a hook near the knives makes the habit far easier to keep.

When honing stops helping

If six or seven swipes per side bring little improvement, there are two likely reasons: the angle is wrong, or the edge is too worn for a rod to fix. Check the angle first, using less pressure if anything. If the knife still tears tomatoes after that, it needs a sharpening stone or another proper sharpening, since honing cannot rebuild an edge that has lost its shape.

For the chef's, santoku and paring knives themselves, see the victorinox knife comparison.