This routine suits any model with removable blades, corded or cordless, and takes about ten minutes when residue has not dried. Start within an hour of carving if you can.
How-to
How to Clean an Electric Knife
How to clean an electric knife: unplug it, wash the blades by hand, wipe the housing, and dry everything before storing it.
The blades of an electric knife can go under the tap, but the handle cannot, and that one split decides almost everything about cleaning it. Meat fibers pack into the serrations and the blade slot soon after carving, so the job is quick when done the same day and tedious when the knife sits overnight.
Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases.
Seven steps to a clean electric knife
- Unplug the knife, or take the battery out of a cordless one, and confirm the switch is off.
- Press the release button and pull each blade out by its handle end, keeping the pair together.
- Wash the blades by hand in warm water with a drop of dish soap, scrubbing the serrated edge with a soft brush from tip to heel.
- Scrub the flat inner faces where the two blades rub together, rinse, and hold them to the light to check for leftover film.
- Wring a cloth out hard in warm soapy water and wipe the housing, the blade slot opening and the release button, then wipe again with a cloth wrung out in plain water.
- Clear crumbs from the blade slot with a short blast of compressed air or a dry bottle brush.
- Towel-dry the blades, let them air out upright for a few minutes, and slide them back in until they click.
Which parts can get wet, and which cannot
Only the blades are made to be washed. Anything that holds the motor, wiring or battery gets a wrung-out cloth at most, because water in the switch or motor is a common way to ruin the tool and a shock risk besides.
Cordless knives add contacts and a charging connection that need the same care, and the electric knife comparison for brisket covers which listed models run on a cord and which on a battery.
- Motor housing: wipe with a damp cloth, never rinse or submerge it.
- Switch and vents: keep water out, and use compressed air for crumbs.
- Battery contacts and charging port: keep them dry and free of debris.
- Cord and plug: wipe off grease with a lightly damp cloth, unplugged.
Which method fits which mess
A hot soapy wash handles nearly every case. Dried-on film, raw poultry or fish, and long storage call for a stronger step. The dishwasher is the shortcut to check first: Homaider lists dishwasher-safe blades, and iKoffy lists a washable handle, but the other listed knives state nothing of the kind, so the maker's manual decides. Even where a dishwasher is allowed, heat and detergent can dull serrations over time.
| Situation | Method |
|---|---|
| Everyday cleaning | Hot soapy hand wash with a brush |
| Dried protein or starch film | Baking soda paste, brief scrub, rinse |
| After raw meat or fish | Diluted sanitizing solution, rinsed well |
| Crumbs in blade slot | Compressed air or dry brush |
| Dishwasher | Only if the manual permits it |
Drying and storing so blades do not rust
Drying matters more than washing. Water trapped between the two blades sits against the steel in a closed drawer, and salty foods such as ham or brined turkey speed up spotting. Never store the pair snapped together while even slightly damp.
Keep the blades in their sleeve or case and the handle in a dry drawer, not a cabinet above the dishwasher where steam collects. A thin wipe of food-safe mineral oil over each blade can add protection between uses. After long storage, give the blades a quick wash before they touch food, since drawer dust and any oil film come off in seconds.