The kit is short, and one item matters far more than the rest. A burr grinder gives an even particle size, while a blade grinder produces fine dust that clogs the paper and makes the cup bitter. Everything else is inexpensive and easy to find.
How-to
How to Brew Pour Over Coffee
How to brew pour over coffee: the ratio, grind, water temperature and six steps that work, plus what changes when the brewer is a Chemex.
Most bad pour over comes down to one dial rather than the pouring itself: the grind. Water that drains too slowly turns the cup bitter, and water that rushes through leaves it sour, so the whole method is built around keeping the drain time in a narrow window. Get the starting numbers right and the rest is a steady hand and a timer.
Affiliate disclosure: As an Amazon Associate I earn from qualifying purchases.
What you need before the first pour
- Dripper: a cone or flat-bottom brewer, or a glass pour over carafe, set over a mug or server
- Paper filters: sized to match the dripper
- Kettle: ideally one with a gooseneck spout for a slow, controlled stream
- Scale: weighing beats scooping because scoops vary
- Burr grinder: for fresh, even grounds
- Timer: a phone works fine
Ratio, grind, temperature and time
Four numbers set up the cup, and each one has a sensible starting point. Begin here, change one thing per brew, and taste the difference before changing another.
| Variable | Starting point | If the cup is off |
|---|---|---|
| Coffee to water | 1:16 by weight | 1:15 stronger, 1:17 lighter |
| Grind | Medium-fine, like table salt | Finer if sour, coarser if bitter |
| Water temperature | 195 to 205°F (90 to 96°C) | Hotter for light roasts |
| Total brew time | About 3:30 to 4:00 | Adjust the grind |
Six steps to a pour over cup
This version makes one large mug: 20 g of coffee and 320 g of water, which is the 1:16 ratio. Bring the kettle to a boil first, then take it off the heat for about 30 seconds so the water lands in the right range. Other brewers follow the same sequence with the quantities scaled.
- Grind 20 g of beans to medium-fine while the water heats.
- Set the paper filter in the dripper over the mug and rinse it with hot water, which removes papery taste and warms the vessel; discard the rinse water.
- Add the grounds, tap the dripper gently to level the bed, then put everything on the scale, tare it and start the timer.
- Bloom by pouring about 40 g of water, twice the coffee weight, over all of the grounds, then wait 30 seconds while the bed swells and releases gas.
- Pour in slow spirals from the centre outward and back, in two or three stages, until the scale reads 320 g.
- Let the bed drain completely, aiming to finish by roughly 3:30 to 4:00, then discard the filter and drink while the cup is still hot.
Using drain time to fix the cup
Total brew time is the most reliable diagnostic, more so than hitting every pour weight exactly. When it runs consistently long or short, the grind is almost always the cause. A drawdown that drags and a cup that tastes harsh point to a coarser grind next time; water that rushes through and a thin, sour cup point to a finer one.
Move one or two settings at a time and keep the beans, ratio and water temperature the same for the retest, so the change is the only thing that changed.
What changes when the brewer is a Chemex
A Chemex works the same way, with two adjustments. Its filters are thicker, which gives an exceptionally clean, tea-like cup but slows drainage, so the grind goes slightly coarser than it would for a thinner-filter dripper. Its capacity is also stated differently: each Chemex cup is measured as 5 oz, so a cup count on the carafe means smaller servings than a typical mug.
For carafe sizes and the bonded filters each model takes, see the chemex comparison. Filters are sold separately from the glass, and the rinse step matters even more with the thicker paper.
Frequently asked
Do I need a gooseneck kettle for pour over?
Not strictly, but it helps with consistency. The thin spout gives control over flow rate and direction, which keeps the grounds evenly saturated, while a standard kettle tends to pour too fast for a precise bloom and spiral.
Can I use pre-ground coffee for pour over?
Yes, though the cup will taste flatter, because ground coffee loses its aromatics quickly. Whole beans ground just before brewing give a noticeably better result, and the grind setting is easier to adjust when a burr grinder is doing the work.