Follow this sequence each time you use the juicer to prevent buildup and maintain extraction efficiency.
How-to
How to Clean and Maintain Your Wheatgrass Juicer
How to clean and maintain your wheatgrass juicer: step-by-step guide to prevent clogs, extend parts life, and keep juice fresh.
A wheatgrass juicer sits between uses gathering dried fiber, mineral deposits, and oxidized plant matter that degrade performance and invite mold. The difference between a machine that juices effortlessly for years and one that clogs or tastes off by season two hinges almost entirely on post-use cleaning habits. Unlike general fruit juicers, wheatgrass equipment needs attention to detail because the grass fibers pack tightly and leaf debris settles into screen mesh. This guide covers the exact steps that keep the machine running like new.
Immediate Cleanup Right After Juicing
Deep Cleaning Steps
- Disassemble the juicer completely: remove the hopper, feed tube, pusher, auger, screen, and any removable seals according to your manual.
- Rinse all parts under cool running water, using a soft brush (typically included) to sweep fibers from the mesh in one direction only.
- Soak the screen assembly in cool water with one tablespoon of baking soda for 15 to 20 minutes to loosen stubborn fiber and mineral deposits.
- Scrub the screen gently with the included brush, moving in one direction to avoid pushing debris deeper into the mesh.
- Rinse thoroughly under running water until the water runs completely clear and no visible pulp remains on any part.
- Wipe the auger with a damp cloth, paying special attention to the spiraling grooves where fiber can lodge between turns.
- Air-dry all parts completely on a clean towel before reassembly or storage.
- For electric models, wipe the motor housing and feed chute with a barely damp cloth, never spraying water directly into the motor casing.
Weekly Deep Maintenance
Storage and Seasonal Care
Replacing Parts and Extending Machine Life
The screen mesh, auger, and seals are wear items. A screen used daily for wheatgrass will eventually trap fibers no matter how well you clean it, and the mesh will thin or the weave will stretch slightly over months or years. When juice starts flowing slower or pulp appears in the juice where it did not before, the screen is nearing end of life. Most manufacturers sell replacement screens at reasonable cost.
Seals and gaskets, if your model uses them, dry out and crack with time. Replace them according to the manual's schedule or when you notice juice or pulp leaking from the seal point. Replacing a seal costs far less than buying a new juicer. When looking at the top wheatgrass juicer options, check whether parts are readily available from the manufacturer or third-party suppliers. Machines with good parts availability justify the purchase because maintenance keeps them running decades rather than years.
Frequently asked
How often should I clean my wheatgrass juicer?
Clean immediately after each use, at minimum rinsing all parts in cool water while fiber is soft. If you juice daily, do a deep soak and scrub weekly. Wheatgrass fibers pack tightly and dry quickly, so same-day cleanup prevents clogs and maintains juice quality.
Can I put my wheatgrass juicer parts in the dishwasher?
Check your manual. Most screens should not go in the dishwasher because heat and harsh jets can damage the fine mesh. Hand-wash the screen gently under cool water with a soft brush. Many housing and hopper parts are dishwasher-safe, but the motor unit never goes in any water-based machine.
What causes wheatgrass juicer clogs, and how do I prevent them?
Dried fiber in the auger grooves and screen mesh causes clogs. Prevent them by cleaning immediately after use, soaking the screen weekly in vinegar solution, and using a soft brush to sweep fibers out of the mesh. Never force material through a sluggish juicer; stop and clean instead.